Den-Mat Sapphire Manuel de l'opérateur télécharger pdf (Page 6)

Basic System Contents

Sapphire

Light Source Operator’s Manual

Light Guide and Tip AC Power Cord

Curing Light Protective Glasses (2 pair) Composite Test Rings (200 each)

Quick Setup Instructions

• Select a handpiece.

• Insert the proximal end of the handpiece’s light guide into the front panel receptacle until it stops.

• Connect the input end of the power cord to the power module on the rear of the system.

• Plug the AC plug into an AC outlet.

Three-conductor grounding plug with international IEC connector provided. This common power cord is used for computers

and other peripheral devices and is readily available for separate purchase if a different plug conﬁguration is needed for

international customers.

• The display on the front panel will light up, indicating that system power is available.

• Turn the power switch (located on the back panel) to the ON ( I ) position.

The Sapphire Plus is now ready for use. It is recommended that you become familiar with all system features before use.

NOTE: Make sure the light guide is pushed all the way in until it stops. Also, it is important to check that the lamp access plate

is on correctly if it has been removed.

ATTENTION: DO NOT PULL ON THE LIGHT GUIDE CABLE TO UNPLUG THE CABLE OR MOVE THE SYSTEM

AC Plug Input

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Pas de commentaire

Den-Mat Sapphire Manuel de l'opérateur Page 6